We use cookies
We use cookies to optimize our website. By continuing to browse the site, you agree to our use of cookies.
New design
Control panel
  • Русский
  • Українська
  • English
  • UAH
  • USD
  • RUB
  • EUR
  • 0-800-307-307 Hotline
  • +38 (044) 392-74-33 Kiev
  • +38 (057) 728-39-00 Kharkiv
  • +38 (056) 794-38-31 Dnipro
  • +38 (032) 229-58-93 Lviv
  • +38 (048) 738-57-70 Odessa
  • +38(093) 170-15-42  Life
  • +38 (067) 400-88-44 Kievstar
  • +1(888)393-24-51  USA, Toll free
  • +44(131)507-01-14  Great Britain
  • +7 (499) 348-28-61 Moscow

2.3.10. Service site address

The service address is designed to check the functionality of a hosted site without a domain - for example, when the domain has not been registered yet, is not working or is not sent to hosting. It is automatically generated for all sites added to the section "My sites", And is disabled by default.

Important points:

  • Initially, the service address is available only for the IP address from which it was generated hosting order, and when you switch to it from another IP, the error “The service address is not available from your IP". To remove the restriction, you need add phone number or pay for hosting service.
  • If the site uses CMSlinked to the domain address, then for the site to work correctly at the service address, it may be necessary to replace the main domain address with a service address inside CMS or making certain changes to its files. For example, in WordPress this can be done by instructions.
  • When the main domain directed to hosting and the service address is included, the site will be available at both addresses - both the main one and the service one.
  • The site can be indexed by the service address. It is recommended to disable it for sites operating on the primary domain to avoid indexing problems.
  • It is not possible to install an SSL certificate or configure HTTPS for the service address. The service address works only over the HTTP protocol.

By default, the service address is disabled:

To enable or disable the service site address, do the following:

  1. Openup site settings.
  2. Uncheck (to enable) or check (to disable) the checkbox opposite “Disable service address»:
  3. Save your changes.
  4. Wait approximately 10-15 minutes for the changes to take effect.

The included service address is a link that you can copy or open the site using it: